2006 Toyota Tundra V8 Oil Change

How to Change Oil and Oil Filter in a 2006 Toyota Tundra

Introduction

Changing the oil and oil filter in your 2006 Toyota Tundra is a relatively simple task that can be completed in about 30 minutes. By following these step-by-step instructions, you can save money on maintenance costs and keep your Tundra running smoothly.

Tools and Materials Needed

• 5 quarts of 5W-30 motor oil
• New oil filter (Toyota part number 90915-YZZD3)
• 14mm socket wrench
• Oil filter wrench
• Drain pan
• Funnel
• Rags

Step-by-Step Instructions

1. Park your Tundra on a level surface and engage the parking brake.
2. Locate the oil drain plug at the bottom of the oil pan. Place the drain pan under the plug.
3. Use the 14mm socket wrench to loosen the oil drain plug. Be careful not to drop the bolt into the oil pan.
4. Allow the oil to drain completely into the drain pan.
5. Once the oil has drained, replace the drain plug and tighten it using the 14mm socket wrench.
6. Locate the oil filter at the top of the engine. Use the oil filter wrench to loosen the filter.
7. Remove the old oil filter and apply a thin layer of new oil to the gasket of the new filter.
8. Screw on the new oil filter by hand until it is snug. Do not overtighten.
9. Add 5 quarts of new 5W-30 motor oil to the engine using the funnel.
10. Check the oil level on the dipstick. The oil level should be between the "L" (low) and "F" (full) marks.
11. Start the engine and let it run for a few minutes.
12. Check for any leaks from the drain plug or oil filter.
13. Turn off the engine and recheck the oil level. Add more oil if necessary.

Conclusion

Changing the oil and oil filter in your 2006 Toyota Tundra is a simple and important maintenance task. By following these instructions, you can save money on maintenance costs and keep your Tundra running smoothly for years to come.